Uline H-4008 Manual Del Usuario página 10

PROBLEM
The inflated material has an
inconsistent air-fill amount.
PROBLEMS WITH THE ROLL WINDING
PROBLEM
The roll winder will not wind
inflated material.
The roll is a different diameter
than expected.
PAGE 10 OF 30
TROUBLESHOOTING CONTINUED
CAUSES
Material roll improperly loaded.
Faulty material.
Electrical or mechanical failure.
Material has been affected by storage
conditions.
CAUSES
The winder is stopped.
The winder is not plugged in.
Obstruction blocking the winder or the
roll.
Electrical or mechanical failure.
The diameter setting is set incorrectly.
Material roll is empty.
Electrical or mechanical failure.
1-800-295-5510
uline.com
RECOMMENDATIONS
Reload material roll – see Loading
the Material Roll.
Load new material roll – see Loading
the Material Roll.
Return material roll – contact Uline
Customer Service.
Contact Uline Customer Service.
Refer to storage conditions under
Safety.
RECOMMENDATIONS
Press the winder start button – see
Producing Air-Filled Material in Roll
Winder Mode.
Verify that the roll winder is plugged
in to the bottom of the machine.
Verify the roll can wind free of
obstruction.
Contact Uline Customer Service.
Verify diameter setting – see
Producing Air-Filled Material in Roll
Winder Mode.
Load a new roll as required – see
Loading the Material Roll.
Contact Uline Customer Service.
0521 IH-4008