Troubleshooting - Uline H-4008 Manual Del Usuario

NO POWER TO THE SYSTEM
PROBLEM
There is no power to the
system and the control panel
display is OFF.
DISPLAYED FAULT MESSAGES
DISPLAYED MESSAGE
#01 E-Stop Pressed
#03 Clamp Open
#08 Check Film Path
#17 Edge Seal Fault
#43 Check Inflation
#51 Check Web Control
PROBLEMS WITH MAKING INFLATED MATERIAL
PROBLEM
The material will not advance
– the control panel is ON.
PAGE 8 OF 30

TROUBLESHOOTING

CAUSES
System is off.
Main power cord is unplugged at the
outlet.
Facility power supply is interrupted.
Electrical component failure.
CAUSES
E-Stop switch pressed.
Edge seal clamp is open.
Out of film.
Material roll is improperly loaded.
Edge seal wheel is missing or not fully
seated.
Edge seal failure.
Material roll is improperly loaded at the
nozzle.
Faulty material.
Electrical or mechanical failure.
Flapper is out of film skirt.
Flapper is faulty, worn or missing.
CAUSES
Material roll is empty.
Material roll is improperly loaded.
Electrical or mechanical failure.
RECOMMENDATIONS
Turn the main power switch to the ON
position.
Verify the main power cord is plugged
into a properly rated outlet – see
Electrical Power Requirements.
Verify facility power supply – see
Electrical Power Requirements.
Contact Uline Customer Service.
RECOMMENDATIONS
Twist E-Stop to release.
Hinge the clamp handle up to close
the edge seal and press reset key.
Load new roll – see Loading the
Material Roll.
Reload roll as required – see Loading
the Material Roll.
Check condition of edge seal and
verify that it is fully seated.
Replace as required – see Replacing
the Edge Seal.
Contact Uline Customer Service.
Reload roll as required – see Loading
the Material Roll.
Load new material – see Loading the
Material Roll.
Return material roll – contact Uline
Customer Service.
Contact Uline Customer Service.
Reload roll as required – see Loading
the Material Roll.
By hand, pull the flapper out of its
mount and fully insert a new one.
RECOMMENDATIONS
Load a new roll as required – see
Loading the Material Roll.
Reload roll as required – see Loading
the Material Roll.
Contact Uline Customer Service.
0115 IH-4008