System Components - Uline H-4008 Manual Del Usuario

SYSTEM DESCRIPTION
The H-4008 Instant Bubble Roll Machine creates
on-demand air-filled cushioning material from a
compact/uninflated pre-formed roll of material. The
inflated material chain is perforated into sections and
can easily be separated by the operator as needed.
There are 3 modes of operation:
MANUAL MODE
• Press the start key to begin producing air-filled
material and the stop key to end production.
BATCH MODE
• Dispense a programmed length of inflated material.
ROLL WINDER MODE
• Requires optional roll winder (H-4621) and stand
(H-4620).
• Dispense a roll of inflated material.
1. ON/OFF Power Switch
This circuit breaker switch controls power to the
system and is located on the back of the system.
2. Emergency Stop Switch (E-Stop)
This emergency stop switch stops all feeding,
inflating and sealing functions.
3. Main Power Cord
Plug this cord into a properly rated receptacle – see
Electrical Power Requirements.
PAGE 2 OF 30
OVERVIEW

SYSTEM COMPONENTS

2
4
6
ELECTRICAL POWER REQUIREMENTS
WARNING! Use of extension cord will increase
the levels of static, resulting in operational
problems.
Inflatable Cushioning System: 115 VAC
Receptacle Type: NEMA 5-15R
A/C Voltage: 100-120 VAC 50/60 Hz
Phase: Single Phase Grounded
Current: 15A Service 4.0A
NOTE: The use of non-Sealed Air materials will
cause production problems, may damage the
equipment and will reduce the quality of the
packaging protection.
1
4. Control Panel
This panel with LCD display and keys is used to
operate, program and diagnose the system – see
Operation.
5. Material Mandrel
This mount provides an unwind position for the
material roll.
6. Edge Seal Assembly
This replaceable component wheel creates an
edge seal to seal air in the material – see Replacing
the Edge Seal.
3
5
0521 IH-4008