Uline H-4008 Manual Del Usuario página 9

PROBLEMS WITH MAKING INFLATED MATERIAL (CONT'D)
PROBLEM
The material advances and
edge seals are present, but
the material does not fill with
air.
The material advances and
fills with air, but the material
does not seal properly.
The inflated material leaks air.
PAGE 9 OF 30
TROUBLESHOOTING CONTINUED
CAUSES
Material roll improperly loaded. The
material layers are not properly
wrapped around the inflation nozzle.
Faulty material.
Electrical or mechanical failure.
Material roll improperly loaded.
Faulty edge seal.
Faulty material.
Seal power out of adjustment.
Electrical or mechanical failure.
Material roll improperly loaded.
Faulty edge seal.
The operator is pulling the inflated
material directly out of the system
before the inflated material can cool.
Faulty material.
Seal power out of adjustment.
Electrical or mechanical failure.
RECOMMENDATIONS
Verify that the open end of the
material is facing in towards the
inflation nozzle – see Loading the
Material Roll.
Load new material – see Loading the
Material Roll.
Return material roll – contact Uline
Customer Service.
Contact Uline Customer Service.
Reload material roll – see Loading
the Material Load.
Check condition of edge seal on the
material.
Check condition of edge seal and
verify that it is fully seated.
Replace as required – see Replacing
the Edge Seal.
Contact Uline Customer Service.
Load new material – see Loading the
Material Roll.
Return material roll – contact Uline
Customer Service.
Remove, re-install and calibrate the
edge seal – see Replacing the Edge
Seal.
Contact Uline Customer Service.
Contact Uline Customer Service.
Reload material – see Loading the
Material Roll.
Check condition of edge seal on the
material.
Check condition of edge seal and
verify that it is fully seated.
Replace as required – see Replacing
the Edge Seal.
Contact Uline Customer Service.
Do not attempt to pull inflated
material from machine.
Contact Uline Customer Service.
Load new material – see Loading the
Material Roll.
Return material roll – contact Uline
Customer Service.
Remove, re-install and calibrate the
edge seal – see Replacing the Edge
Seal.
Contact Uline Customer Service.
Contact Uline Customer Service.
0115 IH-4008