Uline H-4008 Manual Del Usuario página 4

To enter the Operator's Menu, press and hold the Up/
Down arrows ( / ) for 5 seconds.
Film Type Selection Available to the Operator
• ON allows the operator to select film types.
• OFF does not allow the operator to select film types.
Roll Size Adjustment
• Adjust the diameter of the roll when using the
optional roll winder arm. (H-4621)
FILM CODE
ITEM NO. DIMENSIONS
S-19738 Medium Premium (1/2" inflated) 12" x 2,050' Perf 12"
S-19739 Medium Premium (1/2" inflated) 24" x 2,050' Perf 12"
S-19740 Large Premium (3/4" inflated) 12" x 1,250' Perf 12"
S-19741 Large Premium (3/4" inflated) 24" x 1,250' Perf 12"
S-19742 XL Premium (1" inflated) 12" x 1,167' Perf 12"
S-19743 XL Premium (1" inflated) 24" x 1,167' Perf 12"
NOTE: The factory default film setting is S-19740, film
code NJ8R.
CHANGE THE FILM CODE SETTINGS
1. Press the up and down arrows and the reset button
at the same time to access the menu. (See Figure 4)
Figure 4
READY
Film Type 1
11922
PAGE 4 OF 30
OPERATORS MENU
FILM CODE SETTINGS
SETTINGS
A08C
• 20"-40" (50cm-100cm) diameter.
• 2" (5cm) increments.
Batch Size Adjustment Available to the Operator
• ON allows the operator to adjust batch sizes.
• OFF does not allow the operator to adjust batch
sizes.
FILM CODE
Screen
RK8R
RK8G
NJ8R
Select
NJ8K
AO8C
AO8Q
2. Use the arrow buttons to move the cursors on either
side of the screen to Engineering. Press the select
button on the left to select Engineering. (See Figure 5)
Figure 5
>Engineering
Diagnostics
SELECT
Start
Key
MENU SELECT 1
<
BACK
Up
Arrow
Down
Arrow
Reset
Stop
Key
0521 IH-4008