Uline H-4008 Manual Del Usuario página 6

Start Key
Winder Release
Button
PRODUCING AIR-FILLED MATERIAL IN
ROLL WINDER MODE
1. Press the winder release button.
• Press the winder release button to lower the roll
winder.
2. Set the roll diameter.
• Press and hold the Up/Down arrows ( / ) for 5
seconds to enter Operator's Menu.
• Scroll to Menu 2 Roll Size.
• Using the Up/Down arrows ( / ), set the diameter
from 20"-40" (50cm-100cm) in 2" (5cm) increments.
• Press SELECT.
• Press (//) reset to return to the Ready window.
PAGE 6 OF 30
OPERATION CONTINUED
Operator's
Menu
Winder Start
Button
3. Create a 3' (1m) length of inflated material.
• Using the start key, create a 3' (1m) length of inflated
• Using the stop key, stop the system.
4. Slide the leading edge of the inflated material into
5. Start the roll winder.
• Toggle the winder start button to start/stop the roll
6. Remove the finished roll of inflated material.
• The winder will automatically stop once the roll
• Tear at a perforation and slide the roll off of the
O P E R AT O R M E N U
>
R o l l S i z e
B a t c h S i z e
S E L E C T
Winder Slot
material.
the winder slot.
winder.
reaches the programmed diameter.
winder.
2
<
0 2 0
O N
B A C K
0521 IH-4008