Installation Instructions - Johnson JTP9C Manual De Usuario

INSTALLATION INSTRUCTIONS

EXHAUSTING HOT AIR
In the Cool Mode the appliance must be placed close
to a window or opening so that the warm exhaust
air can be ducted outside.
First, position unit on a flat floor and make sure there's
Extend the hose
a minimum of 18" (45cm) clearance around the unit,
and is within the vicinity of a single circuit outlet
power source.
1. Extend either side of the hose (Fig.1) and screw
onto the hose (Fig.2).
2. Extend the other side of the hose and screw it to the
hose outlet (Fig.3).
3. Install the hose inlet into the unit (Fig.4).
Fig.4
Your window slider kit has been designed to fit most standard vertical and horizontal
window applications. However, it may be necessary for you to modify some aspects of
the installation procedures for certain types of windows. The window slider kit can be
fastened with screws.
NOTE: If the window opening is less than the minimum length of the window slider kit,
cut the end without the hole in it short enough to fit in the window opening. Never cut
the window kit attachment piece with the vent hose hole in it.
V.1
12