Cleaning; Cleaning The Cabinet; Cleaning The Air Filters; End Of Season Operations - Johnson JTP9C Manual De Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CLEANING

Before cleaning or maintenance, turn the appliance off by pressing the
control panel or remote control, wait for a few minutes, then unplug the unit.

CLEANING THE CABINET

You should clean the appliance with a slightly damp cloth then dry with a dry cloth.
Never wash the appliance with water. It could be dangerous.
Never use petrol, alcohol or solvents to clean the appliance.
Never spray with insecticide liquids or similar solutions.

CLEANING THE AIR FILTERS

To keep your appliance working efficiently, you should
clean the filter every week of operation.
The air filter can be taken out as shown in this figure.
Use a vacuum cleaner to remove dust accumulations from
the filter. If it is very dirty, immerse in warm water and rinse
a number of times. The water should never be hotter than
104℉(40℃). After washing, leave the filter to dry then attach
the intake grille to the appliance. Do not put a wet air filter
back into the air conditioner as damage could occur.
START AND END OF SEASON OPERATIONS
START OF SEASON CHECKS
Make sure the power cable and plug are undamaged and the ground wire is efficient.
Follow the installation instructions precisely.

END OF SEASON OPERATIONS

To empty the internal circuit completely of water,
remove the cap on the condenser drain (Fig. 32).
Run off all water left into a basin. When all the water
has been drained, put the cap back in place.
Clean the filter and dry thoroughly before storing
the unit.
V.1
Fig.32
30
button on the

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Jtp12h

Tabla de contenido