Altrad MIX125 Manual De Instrucciones página 16

4 - INSTRUCTION ASSEMBLY / DISPLACEMENT AND TRANSPORT
Instruction assembly
4.1 -
Insert the support leg ( b ) into the main frame ( a) and secure with the bolt and nut.
Slide the wheels onto the main frame bar and anchor them in place with the cotter pins.
Fit the gearbox frame and motor assembly ( a ) into the swivel bracket ( b) with the anchor pin ( c ); slide the cotter pin through the
anchor pin hole. Pay attention to the assembling position of the swivel bracket (ref. below to the drawing on the right).
Slide the swivel bracket ( a) onto the main frame ( c ) upright. The motor support ( b ) is mounted into this swivel bracket.
Mount the mixing drum onto the gear-box shaft by aligning the guide notch with the locating pin on the gear shaft with the T-handle
bolt a and washers
16