Chapin MIXES 63950 Manual De Uso Y Cuidado página 11

DISASSEMBLING AND REPAIRING THE PUMP ASSEMBLY
1. Release the pressure from the sprayer and remove all liquid from both the pressure chamber and tank.
2. Loosen hose clamp and remove hose.
3. Remove the In-tank filter from the pressure chamber.
4. Remove 2 bolts attaching the pivot lever to the pump shaft and remove piston assembly (fig. 2a & 2b).
5. Remove large clamp holding the pressure chamber and tank together (fig 1).
6. Rock the pressure chamber back and forth and push down to free it from the tank (fig 1).
7. Once freed the entire pump assembly can be removed by maneuvering it through the base frame
(fig 3a & 3b).
8. The pressure chamber o-ring can also be replaced. DO NOT stretch the o-ring over the bottom flange.
Assemble the o-ring over the top of the chamber. Apply petroleum jelly to the o-ring before reinstalling pump
asembly into the tank (fig. 3b).
9. Reassemble by attaching components in reverse order.
NOTE: When attaching frame assembly, align tank groove and pump groove ( Fig. 4).
Lock in place with frame tab (Fig. 5) to secure all 3 components. Secure frame assembly with 2 bolts (Fig. 6).
In-Tank
Filter
Figure 1
Tank
Groove
Figure 4
Figure 2b
Tank
Groove
Frame
tab
Pump
Groove
Figure 5
Pressure
Chamber o-ring
Figure 2a
Figure 3a
Pump
Groove
10E
Figure 3b
Frame
tab
Bolt
Figure 6
Pump
Assembly
Clamp
Bolt