Installing The Shoulder Strap - Chapin MIXES 63950 Manual De Uso Y Cuidado

SPRAYER COMPONENTS & USE INFORMATION, Continued
INSTALLING THE PUMP HANDLE
The pump handle can be mounted on either side of the pump shaft (A). To
install the pump handle place the handle (C) over the shaft (A) aligning the
pump handle holes and shaft holes. Slide the bolts (B) through the aligned
holes as shown in figure 3. Tighten nuts (D) to bolts. There are holes in the
pump handle to allow for either left (fig.2-4) or right (fig.5) hand mounting.
Nylon Lock Nut
Threaded Bolt
Figure 1
Figure 4
Tighten nut to bolt

INSTALLING THE SHOULDER STRAP

The backpack strap is provided with multiple features including
shoulder strap, chest strap, waist belt and lumbar support. (figure
1). The top the shoulder strap is attached to the top of the tank and
is removable (figure 2). The hook from the lumbar support attaches
to the base tube on the bottom of the tank. Position lower strap clip
hook as shown, under base rail on a solid and stable surface. Push
down on sprayer to snap clip onto rail (figure 3).
Figure 2
Shoulder Strap to top of tank
Base
Tube
Lumbar
Support
Hook
Figure 3
Hook Attachment
Pump
Handle
Pump
Shaft
Figure 2
Line up holes
Figure 5
Right Hand
Figure 3
Slide bolts through holes
Completed Assembly
Hook location
3E
A. Pump Shaft
D. Nuts
C. Pump Handle
Figure 1
Strap Assembly
B. Bolts
Shoulder
Strap
Chest
Strap
Lumbar
Support
Waist Belt