Safety Procedures And Notes Before Switching The Machine On; Routine Inspection - Skymsen PSP-98M/T Manual De Instrucciones

4.1.3 Advices
* In case of power shortage, immediately switch the machine off.* Use recommended or
equivalent lubricants, oils or greases.
* Avoid mechanical shocks, once they may cause damages or bad functioning.
* Avoid water, dirt or dust contact to the mechanical and electrical components of the
machine.
* DO NOT change the standard characteristics of the machine.
* DO NOT remove, tear off or maculate any safety or identification labels stuck on the
machine. If any labels have been removed or are no longer legible, contact your nearest
dealer for replacement.

4.2 Safety Procedures and Notes before Switching the Machine ON

Carefully read ALL INSTRUCTIONS of this manual before turning the machine ON.
Be sure to well understand all the information contained in this manual. If you
have any question contact your supervisor or your nearest Dealer.
4.2.1 Danger
An electric cable or electric wire with damaged jacket or bad insulation might cause
electrical shocks as well as electrical leak. Before use, check the conditions of all wires
and cables.
4.2.2 Advices
Be sure to well understand all the information contained in this manual. Every operation
function or procedure has to be thoroughly clear.
Before using any commands (switch, buttons, lever), be sure it is the correct one. In case
of doubt, consult this manual.
4.2.3 Precautions
The electric cable has to be compatible with the power required by the machine.
Cables touching the floor or close to the machine need to be protected against short
circuits.

4.3 Routine Inspection

4.3.1 Advice
When checking the tension of the belts or chains, DO NOT insert your fingers between the
belts and the pulleys and nor between the chain and the gears.
16
IMPORTANT