3.3 Security System
This equipment has a safety system that prevents the device from restarting automatically
when the power is restored after a temporary disconnection.
This equipment has a security system to ensure the integrity of the operator. The
operation of the equipment must be in accordance with the item "Operation"
of this manual. Other procedures to operate the equipment are unsafe, in this
The feeding nozzle has a fixed physical protection No. 01 (Picture 04) that prevents the
access of the lower limbs to the risk zone.
The discharge nozzle has a physical protection that prevents access to danger areas.
The No. 01 auger, the No. 02 disk and the No. 03 knife form a single set, as shown in
Picture 05. To access the risk area, the set needs to be pulled, disconnecting the set from
the motor source.
The equipment must be operated with all safety systems, failure to use it can cause
serious injuries to the upper limbs, such as: crushing, breaking and shearing.
10
condition the equipment should not be used.
01
Single Set
IMPORTANT
PICTURE 04
PICTURE 05
03
IMPORTANT
01
02