Brandt BOP7542X Instrucciones Para El Usuario página 69

Using your device
WIFI CONNECTION: QUESTIONS AND ANSWERS
Q u e s t i o n s
I'm moving or
changing my Wifi
network settings
I sell my product
I don't know
where the QR
product code is
Declaration of conformity
We, Brandt France, declare that the device equipped with the Smart Control function complies with Directive 2014/53/EU.
The full EU Declaration of Conformity is available at www.sauter-electromenager.com.
2.4 GHz frequency band : Max power 100 mW (20 dbm)
Brandt cannot be held responsible:
In case of failure, loss, delay or error in the transmission of data that are beyond its control, if data did not reach it, for any reason, or if the data it receives were illegible or impossible to
process; in case the user was unable to access or use the application and associated services for any reason, the connection should be suspended or interrupted.
Furthermore, Brandt declines all responsibility in case of misuse of the terminal and/or any incident related to the use of the terminal during the application.
Brandt can in no way be held responsible for any damage of any kind whatsoever caused to your terminal and the data stored on it, nor for the consequences that may result from it.
* For security reasons, each appliance can only be connected to one user account. Consequently, in the case of a change of user of the device (transfer of the
device for example) the former user must delete his user account from his mobile application. The new user must ensure that the deletion has been completed
before he can create his own account by following the same installation and registration steps described in this manual.
However, the same user account can be used on multiple mobile phones or tablets. Therefore, in the case of a change of user of the device (e.g. transfer of the
device) the former user must delete his user account from his mobile or tablet application.
Note :
The previous day's display (see Settings menu P.16): After 90 seconds of inactivity the display
goes off, the Wifi connection is still active.
Council
If wifi is enabled you can use the Skip Smart Control function.
In standby mode with maintained network connection the device consumes at most
2W.
28
- Re-pairing the product .
1- Reset the product, Oven settings menu then Wifi then
Reset:( see Settings Menu).
2- Smartphone application, see Menu then Product management then
Reconnect the product.
- From the application menu go to "Product management" then "Delete my product".
- If you have only one product you can delete your customer account via the
application in My Account and then delete the account.
- To establish the connection with your oven, the application will ask you to
scan its QR-code or enter its serial number. This information can be found
on the type plate similar to the one below, which is visible when you open
the oven door..
XXXXXXXX
SERVICE : ------------ TYPE : -----------------
H
Nr. XX XX XXXX
A n s w e r s & S o l u t i o n s
B: Commercial reference
C: Service reference
H: Serial number
I: QR Code
CE
I