Depth Stop; Fitting/Removing A Tool; Quick-Release Chuck For Round Shaft Drill Bits; Use - Parkside PBH 800 A1 Traducción Del Manual De Instrucciones Original

NOTE
► Turn the additional handle
locking positions depending on your working
position . Undo and lock the additional han-
dle as described previously .

Depth stop

♦ Undo the wing screw
♦ Insert the depth stop
handle .
♦ Ensure that the toothing on the depth stop
facing downwards .
♦ Pull the depth stop
between the tip of the drill and the tip of the
depth stop with the required drilling depth .
♦ Retighten the wing screw

Fitting/removing a tool

WARNING!
► Switch the appliance off and remove the
power plug before starting any work on the
appliance .
Fitting a tool:
♦ Before fitting a tool, grease the tool holder
lightly with machine grease .
♦ To insert, pull the locking collar
and insert the tool .
♦ Release the locking collar
tool holder . Check that the tool is properly
locked by pulling it . The system has radial play
because of the design .
Removing a tool:
♦ To release the tool, pull the locking collar
backwards .
Quick­release chuck for round shaft
drill bits
WARNING!
► Do not use the quick-release chuck
hammer drilling or chiselling!
♦ Set the function selector switch
symbol .
■ 36 │ GB │ MT
into the various
.
into the additional
out until the distance
afterwards .
backwards
. This locks the
for
to the drill
Inserting the quick-release chuck for round
shaft drill bits:
♦ To insert the quick-release chuck
fig . A) pull the locking collar
Insert the quick-release chuck
♦ Release the locking collar
tool holder
locked by pulling it .
Removing the quick-release chuck for round
shaft drill bits:
♦ To remove the quick-release chuck
is
locking collar
quick-release chuck

Use

Select operating mode

Function selector:
♦ Press and hold the release button
function selector switch
selector switch
engages at the arrow mark:
Function
Drilling/screwing
Hammer drilling
Chiselling
Chisel position adjust-
ment
Adjusting chisel position:
You can rotate the tool to the required position for
chiselling using this function .
♦ Turn the function selector switch
♦ Turn the tool in the tool holder
position .
♦ Turn the function selector switch
for the chiselling function .
(see also
backwards .
.
. This locks the
. Check that the tool is properly
backwards and remove the
.
. Turn the function
so that the required symbol
Symbol
to position .
to the required
to position
PBH 800 A1
, pull the
on the