Overview Window - VOSS.farming FM10 Instrucciones De Operación

INSTRUCTION MANUAL VOSS.FARMING FENCE MANAGER FM10
6.2

OVERVIEW WINDOW

a
- Indicates the audible alarm is
active
b
- Device type/GX or MX ID
G: Generator/electric
ƒ
energiser
M: Monitoring device/Fence
ƒ
Sensor
X: Additional ID/distinguishes
ƒ
between electric fence
energisers (1–6) and Fence
Sensors (A-F)
Info
► Devices with identical names
cannot be operated.
► A Fence Sensor can be added
to an electric fence energiser
as a subordinate node or
can form a separate node.
Further details can be found in Section 9.3.
c
- Status and power level of the electric fence energiser
Power at 0%: the electric fence energiser is switched off, however, it will
ƒ
continue to send data to the device (standby mode) - see G3
Power at 50%: the electric fence energiser is switched on and set to half
ƒ
power - see G2
Power at 100%: the electric fence energiser is switched on and set to full
ƒ
power - see G1
d
- Last measured voltage on the electric fence energiser [kV]
e
- Signal strength between the Fence Manager and the paired device
f
- Battery status of the electric fence energiser or Fence Sensor, if connected
g
- Indicates the last data transmission
A bar display is located below each device. It
ƒ
shows how much time has elapsed since the last
information was sent. The transmission interval
between the electric fence energiser and the
Fence Manager is one minute. The transmission
interval between the Fence Sensor and the Fence
Manager is 15 minutes.
The bar is displayed if radio contact is lost for
ƒ
more than two minutes.
An alarm is triggered once the bar underlines the
ƒ
full width of the device display. The bar is reset if
data has been transmitted in the meantime.
41650 | 12 | 2020 | V2
fence
2 min.
Failure at G1
5 min.
20 min.
Failure at G2
60 min.
Failure at G3
(Alarm is triggered)
DE
EN
EN
FR
IT
NL
SV
ES
PL
35