Important - Oki MICROLINE 8810 Guia De Instalacion

Load Continuous Forms
1. Push the sheet supports in and lift the sheet feed
platform
2. Lift the lock lever on the left tractor, then move
the left tractor to set the desired left margin for
printing.
• The ▼ mark on the gauge (1)—or the center of
the diamond shaped hole (2)—represents the
location of the center of the first character
printed.
Note
The movement of the left tractor is limited to
ensure that the paper covers the paper out
sensor.
8480_2_crop.jpg
F5-04a.jpg
3. Push the lock lever down to lock the left tractor in
place.
4. Lift the lock lever (1) on the right tractor (2) and
F5-05a.jpg
F5-03a.jpg
5. Open both tractor covers and place the first three
6. Close the tractor covers and fine tune the position
7. Lower the platform.
9
move the tractor over to correspond to the width
of the continuous forms you are using. Center the
paper support (3) between the two tractors.
holes in the continuous forms paper over the pins.

Important!

Make sure that an equal number of paper holes
are engaged on each tractor. If not, the paper
will jam.
of the right tractor until the holes in the paper are
centered on the pins, then push back the right
tractor lock lever.
F5-06a.jpg
F5-06b.jpg
F5-07a.jpg