Yakima FreshSesh Manual De Instrucciones página 2

YaKima Q toWerS: Do not repoSition Your toWerS!
remove baSe SCrew
Use hex wrench.
faCtory barS:
CheCk for proper SCrew Length
• Some factory bars may
require the long bail
screws.
• Screws must extend
below bail.
work on a fLat SurfaCe
Open carrier (they open two ways):
LiFt Bottom oF Button...
1033382C-2/15
CROSSBAR
SPREAD
if screws are too short,
use the longer screws
included
puSH top oF Button...
-or-
SKiS anD BoarDS
unDer 170 cm:
Crossbar spread must be
between 12" and 24"
SKiS anD BoarDS
oVer 170 cm:
Crossbar spread must be
between 12" and 36"
remove one baiL SCrew
• Use hex wrench.
• Loosen the
remaining screw,
but leave it in place.
In some cases, the bails
may not be parallel.
ok
open