Yakima BuckHorn 4 Elite Manual De Instrucciones página 2

DO NOT USE THIS PRODUCT WITH HITCH EXTENDERS! USE ONLY YAKIMA ADAPTERS
WITH THIS PRODUCT. DO NOT USE ANY OTHER BRAND TONGUE ADAPTER.
Pull out the pin and wire-
lock from the hitch plate.
Install tongue.
Push the tongue into the hitch plate, aligning the holes.
• Install one of the hex bolts and a flat washer.
• Add a second washer, attach a nut.
ATTAch The sTOP bOlT
ANd bOlT sleeve.
• Install bolt, passing
through sleeve.
• Attach nut., TIGHTEN
with 9/16" wrenches.
DO NOT OVERTIGHTEN!
1033606B-2/15
FOR 1-1/4" HITCHES ONLY. Remove 2" adapter.
FOR 1-1/4" HITCHES ONLY. Remove 2" adapter.
• Remove bolt with wrench.
• Remove adapter.
INsTAll sAfeTy PIN ANd WIRe-lOck.
Safety pin and wire-lock
must be in place when
bikes are loaded.
Pin is only removed for
access to vehicle.
TIGHTEN with 9/16" wrenches.
1-1/2 to 2 threads
should be visible
above the nyloc
portion of the nut.
• Pivot tongue to fit into hitch plate.
• Align holes and insert pin.
Nyloc
REPLACE
WIRE-LOCK.