Yakima BuckHorn 4 Elite Manual De Instrucciones página 4

Load largest or heaviest bike first.
routed under
To fold mast down and access the rear:
• Unload the bikes.
• Release safety pin and wire-lock.
Pull wire
lock.
Release
pin.
1033606B-4/15
wheel strap
• Pull straps tight,
diagonally over
The straps
frame, hook into
can be
place.
the cables.
Load additional bikes.
long strap
• Alternate bike directions to avoid interference.
• Use Long Strap to secure bikes to carrier's frame.
• Secure loose strap end.
• Always load first bike with chain away from vehicle.
• Always use cradles closest to vehicle.
• Use Wheel Strap to secure rear bike's front wheel to it's frame.
• Secure loose strap end.
A yakima TubeTop (see cover
page) may be required to
carry your bike safely.
Failure to load bikes properly
can result in property damage,
personal injury, or death.
Bikes should be as level as possible to avoid ground
clearance issues and possible ejections.
Lock bikes (optional).
• Thread security cable around carrier
frame and insert through cable's loop.
• Thread the cable through each
bike wheel, and all bike frames.
• Insert the slider pin into
the lock and lock it.
• Verify that the pin is secure by
pulling on the locked cable.
Stabilize the
bike frame in
the cradles.
Arrange
bikes for best
stabilization.