Winix ZERO Pro Manual De Usuario página 15

FILTER CARE
3. Filter Assembly and Replacement
Filters should be re-installed in the reverse order of their removal.
Insert the replacement
①
3 True HEPA filter (rear)
2 AOC™ Carbon Filter (middle)
ˍ Remove the protective plastic wrap from
new filters. Operating the unit without
removing the protective plastic wrap
may cause abnormal noise, deformation,
or fire as a result of overheating.
Insert the 1
②
ˍ To install the pre-filter, insert bottom
tabs into the slots on either side of
the lower part of the unit, then rotate
upward to insert the upper tabs into
the slots at the top part of the unit until
both sides audibly click into place.
Replace the front panel by first inserting
③
the latch at the bottom edge into the
base of the unit, then rotate the panel
upward toward the top of the unit until it
magnetically snaps closed.
After replacing the filters, turn the power
④
back on and then use a thin object, such as
a paper clip, to press the RESET switch for
5 seconds.
English
Pre-filter (front)
True HEPA
3
lter
AOC
TM
2
Carbon Filter
ZERO Pro
15