Muffler; Starter Housing; Changing A Broken Or Worn Starter Cord - Husqvarna T525 Manual De Instrucciones

• Make sure the vibration damping units are securely
attached to the engine unit and handle unit.
Stop switch
• Start the engine and make sure the engine stops
when you move the stop switch to the stop setting.
Muffler
• Never use a machine that has a faulty muffler.
• Regularly check that the muffler is securely attached
to the machine.
30 – English
MAINTENANCE
The muffler is designed to reduce the noise level and to
direct the exhaust gases away from the operator. The
exhaust gases are hot and can contain sparks, which may
cause fire if directed against dry and combustible
material.

Starter housing

!

Changing a broken or worn starter cord

• Loosen the screws that hold the starter against the
crankcase and remove the starter.
• Pull out the cord approx. 30 cm and hook it into the
notch in the rim of the pulley. Release the recoil spring
by letting the pulley rotate slowly backwards.
WARNING! When the recoil spring is
wound up in the starter housing it is
under tension and can, if handled
carelessly, pop out and cause personal
injury.
Care must be exercised when replacing
the return spring or the starter cord.
Wear protective glasses and protective
gloves.