Troubleshooting - Cooke & Lewis CLAG60 Manual Del Usuario

Safety
C. Information for dismantling.
This appliance cannot be dismantled by the user, other than that as shown in the original assembly of the
user manual.
At the end of its useful life, the appliance should not be disposed of with household waste. Check with your
local governmental authority, domestic waste disposal services or the retailer where the product was
bought for recycling advice.

Troubleshooting

Problem
Excessive vibration.
The light is on, but the
fan does not work.
Both the light and
motor do not work.
Suction performance
reduced.
Works normally but
cooking smells linger.
This appliance respects laws of the suppression of radio interference. As the Manufacturer has a policy of
continuous product improvement, it reserves the right to adapt and carry out any modification considered
necessary without prior warning.
Kingfisher International Products Limited, 3 Sheldon Square, London, W2 6PX, United Kingdom
208862_s1_s2-5059340127538-C&L-A5-SM-Safety-V03.indd 9 208862_s1_s2-5059340127538-C&L-A5-SM-Safety-V03.indd 9
Possible cause
The appliance is not installed properly
on the brackets.
The fan blade is damaged.
The fan motor is not fixed tightly.
The fan blade is jammed.
The motor is damaged.
Light bulb blown.
Power connection loose.
Speed may be too low.
Aluminium filters are dirty.
Top vent might be obstructed.
Optional vent kit might be twisted.
The installation may not comply with
the manufacturers instructions.
Carbon filter is not fitted in
recirculation mode or is full of grease.
Solution
Take down the appliance and check
it is properly fixed.
Switch off the appliance. Repair to
be carried out by qualified service
personnel only.
Ring the customer helpline at the
end of the Care & maintenance
section to arrange an engineer visit.
Check power supply.
Select a higher speed.
Clean the aluminium filters. (See
Care and maintenance section).
Clear any obstruction.
Ensure that the vent kit is fitted
according to the manufacturer's
instructions.
The vent hose should be correct
diameter throughout with no
reductions or restriction. (See
installation section).
Fit carbon filter or replace the
carbon filter (See Care and
maintenance section).
09
6/11/2020 6:18 PM 6/11/2020 6:18 PM