Dremel 8050 MICRO Traducción De Las Instrucciones Originales página 11

wires will be discharged during the run-in
time.
c. Direct the discharge of the spinning wire
brush away from you. Small particles and
tiny wire fragments may be discharged at high
velocity during the use of these brushes and
may become imbedded in your skin.
d. Do not exceed 15,000 RPM when using wire
brushes
DO NOT WORK WITH MATERIALS
!
CONTAINING ASBESTOS (asbestos is
considered carcinogenic)
TAKE PROTECTIVE MEASURES WHEN
!
DURING WORK DUST CAN DEVELOP
THAT IS HARMFUL TO ONE'S HEALTH,
COMBUSTIBLE OR EXPLOSIVE (some dusts
are considered carcinogenic); wear a dust
mask and work with dust/chip extraction when
connectable
SPECIFICATIONS
Model number . . . . . . . . 8050
Voltage. . . . . . . . . . . . . . . 7.2 Vdc
Speed . . . . . . . . . . . . . . . 28,000/min
Collet capacity ∅ . . . . . . . 3.2 mm
Max. accessory ∅ . . . . . . 38.1 mm
Battery capacity . . . . . . . . 7.2 Wh
Weight . . . . . . . . . . . . . . . 0.3 kg
CHARGER
Input. . . . . . . . . . . . . . . . . 220-240 Vac, 50/60 Hz,
Output . . . . . . . . . . . . . . . 12.0 Vdc, 500mA
Weight . . . . . . . . . . . . . . . 0.2 kg
Always check that the supply voltage is
the same as the voltage indicated on the
nameplate of the charger.
GENERAL
A. Collet nut
C. Shaft lock button
D. Wrench
E. On/Off button
F. Speed control buttons
G. Battery charge light
H. Charging terminals
I. Speed control & charge indicator lights
J. Accessory storage
K. Ventilation openings
L. Charging base
M. Outlet for power supply
N. Jack for charging base outlet
O. Frontal LED lights
P. Power adapter
The light of this power tool is intended to
illuminate the power tool's direct area of working
operation and is not suitable for household room
illumination.
NOTE: This tool is not compatible with
attachments.
150mA
7
CHARGING AND BATTERIES
• This charger can be
used by children aged
8 and above and by
persons who have
physical, sensory or
mental limitations or a
lack of experience or
knowledge if a person
responsible for their
safety supervises them
or has instructed them
in the safe operation
of the charger and
they understand the
associated dangers
(otherwise there is a
danger of operating
errors and injuries)
• Supervise children (this
will ensure that children
do not play with the
charger)
• Only use DREMEL charger 2610033984
(U.K. 2610033986) with this tool
• Do not expose tool/charger to rain
• Do not charge tool in damp or wet
environments
• Do not use charger when damaged; take it
to one of the officially registered DREMEL
Service Stations for a safety check
• Do not use charger when cord or plug is
damaged; cord or plug should be replaced
immediately at one of the officially registered
DREMEL Service Stations
• Do not disassemble charger
• Permitted ambient temperatures (tool/
charger):
– when charging 0...+45ºC
– during operation -20...+50ºC
– during storage -20...+50ºC
CHARGING BATTERY PACK
1. Be sure to charge tool prior to initial use.
2. Plug the power adapter jack onto the charging
base and insert the power adapter plug into
your standard power outlet.
3. Place tool in charging base as shown in
picture 7.
11