Mansfield NYREN 760 Instructivo De Instalación página 2

grounded, a qualified electrician or maintenance
personnel should help to check and ensure it. The
electrical power source socket wiring should be:
left for the null line *and right for the fire line*.
Never reverse power line wiring.
- This product should be used with a 110V-120V,
60Hz electrical current only, and a load current
of at least 10A. The power plug must be equipped
with a ground fault circuit interrupter, a ground
fault electrical leakage protector, or a similar
high-sensitivity, rapid-type leakage switch (rated
sensitive current under 10mA).
- It is recommended to use a waterproof electrical
outlet, which should be installed in a place where
it won't easily get wet.
- The old, aging water supply hose can't be
used, otherwise it might cause leakage, fire, or
electrical shock. Installation of the bidet seat
should only be performed with the included and
specified components (including a new water
hose).
- When moving the product from a cold or wet
environment into normal room temperature, wait
for two hours until the condensation water is fully
evaporated. Doing so can prevent the product
from electrical short-circuit.
- It is strongly recommended to unplug the unit
during a thunderstorm.
- Do not use the product in the places close to a
bathtub or water tank.
- Do not place the product in water or other liquids.
- Do not touch the product if it has fallen into a
liquid, immediately pull out the power plug.
- Do not stand on product unit, seat and cover.
- Do not hit the ceramic; a heavy impact on ceramic
leads to damage and water leakage.
- Never embed a ceramic toilet base in
cementitious material (such as cement mortar).
It may lead to expansion cracks.
2
-
Do not use thinners, gasoline, bleach detergents,
insecticides, toilet cleaners, and scrubbing
brushes to clean the product. Only use tap
water or potable water; otherwise it may cause
scratching. Exposure to direct sunlight must be
avoided.
- This product is equipped with a soft-closing seat
cover. Heavy pressing or pushing may damage
the soft-closing damper.
- Do not connect the water supply to the heater
outlet. Make sure the inlet water temperature is at
3-35°C, exceeding the specified range will result
in the built-in heating module malfunction.
- Do not lean back against the seat cover when
using the product, to avoid damage.
- Do not try to flush newspapers, diapers, sanitary
napkins, and other items that may easily clog the
toilet.
- Stop using the product and shut off the power
if the product malfunctions. Please contact
customer service for professional help.
- When installing, disassembling, repairing, and
maintaining the product, you must unplug the
power supply and close the water supply valve.
- Do not use in an environment below 0°C. If the
room temperature is below 0°C, the water in the
toilet must be drained to prevent the tank from
freezing. To prevent damage caused by freezing,
please implement warming measures to increase
the temperature of the toilet.
- If it is not used for a long time, the power must be
turned off and the water in the water unit should
be drained.
- Childen and individuals with physical, sensory or
intellectual deficits should use this product under
the supervision of a capable adult.
- Individuals with heart disease should use caution
when operating this product.
www.mansfieldplumbing.com