Tripp-Lite PDUMNH16HVAT El Manual Del Propietario página 7

3. Features
2
Digital Display: Shows source status, measured values, display modes and other information.
See the Digital Display section for detailed explanations of the indicators and displays.
3
A
Status LED Color
A
Off
Steady Green
Flashing Amber
4
Mini-DIN Serial Port: Use this port to provide a direct terminal connection to a computer
with a terminal emulation program.
5
PS/2 Port: Use this port to connect a Tripp Lite ENVIROSENSE environmental sensor to
provide remote temperature/humidity monitoring and a dry contact interface to control and
monitor alarm, security and telecom devices.
6
SNMP Reset Button: Press the reset button for 3 seconds to reboot the ATS network card.
Rebooting the network card will not erase network settings or interrupt AC power. The reset
button is recessed. Use a paper clip or other suitable object to press it.
7
ATS Output: This cord is permanently attached to the ATS (see chart on pg. 4).
8
Chassis Ground Screw: Use this to connect equipment that requires a chassis ground.
15-09-215-93338F.indb 7
Network Interface: Use the RJ-45 jack to connect the ATS to the network
with a shielded Ethernet patch cable. The Status LED
B
indicate operating conditions as shown in the table below. These ports are
not compatible with PoE (Power Over Ethernet) applications.
Network Operating Conditions
Card Not Initialized
Card Initialized and Operational
Error - Card Not Initialized
Link LED Color
B
Off No Network Connection
Flashing Amber 100 Mbps Network Connection
Flashing Green 10 Mbps Network Connection
7
and Link LED
A B
9/30/2015 4:56:29 PM