Networking The Ats; Features - Tripp-Lite PDUMNH16HVAT El Manual Del Propietario

2. Installation

2.3 Networking the ATS

Your ATS can receive its IP address assignment via DHCP server (dynamic) or static (manual)
addressing methods. If you are uncertain which method to use, contact your network administrator
for assistance before continuing the configuration process.
Note: The MAC address (12-digit string in this format: 000667xxxxxx) is printed on a label and attached to the ATS
enclosure. For static IP address assignment, use the DB9 configuration cable (730866) included with the ATS.
The ATS provides remote monitoring and more via Web browser, telnet and SNMP-based Network
Management Systems. For more information about configuration and operation of the ATS via the
PowerAlert Web browser interface, refer to the SNMPWEBCARD User's Guide by going to
www.tripplite.com/support and typing SNMPWEBCARD into the search field.

3. Features

6 4
3 8
1
1
ATS Source A and Source B Input: The cords are permanently attached to the ATS. The
following plug types are used for each model:
IEC 309 16/20A
BLUE (2P + E)*
Model
PDUMNH16HVAT
PDUMNH20HVAT
PDUMNH30HVAT
PDUMNH32HVAT
*Dual-agency rated plug
15-09-215-93338F.indb 6
5
7
NEMA L6-20P
Input Plug Type
IEC 309 16/20A BLUE (2P + E)*
NEMA L6-20P
NEMA L6-30P
IEC 309 32A BLUE (2P + E)
2
NEMA L6-30P
Output Receptacle Type
IEC 309 16/20A
NEMA L6-20R
NEMA L6-30R
IEC 309 32A
6
IEC 309 32A
BLUE (2P + E)
9/30/2015 4:56:28 PM