Important Safety Instructions - Tripp-Lite PDUMNH16HVAT El Manual Del Propietario

1. Important Safety Instructions

SAVE THESE INSTRUCTIONS
This manual contains instructions and warnings that should be
followed during the installation, operation, and storage of this product.
Failure to heed these instructions and warnings may affect the
product warranty.
• The ATS provides a convenient dongle outlet, but it DOES NOT provide surge or line noise
protection for connected equipment.
• The ATS is designed for indoor use only, in a controlled environment, away from excess moisture,
temperature extremes, conductive contaminants, dust or direct sunlight.
• The ATS can only be used in a Restricted Access Location where access can only be gained by
qualified service personnel.
• Keep indoor ambient temperature between 32°F and 122°F (0°C and 50°C).
• The ATS must be installed by a qualified technician only.
• Do not attempt to mount the ATS to an insecure or unstable surface.
• Install in accordance with National Electrical Code standards. Be sure to use the proper
overcurrent protection for the installation, in accordance with the plug/equipment rating.
• Connect the ATS to an outlet that is in accordance with your local building codes and that is
adequately protected against excess currents, short circuits and earth faults.
• Do not power on and use the ATS with one plug exposed.
• The electrical outlets supplying power to the equipment should be installed near the equipment
and easily accessible.
• Do not connect the ATS to an ungrounded outlet or to extension cords or adapters that eliminate
the connection to ground.
• Be sure to provide a local disconnect device on any models that are permanently installed
without a plug that is easily accessible.
• Disconnect both AC input sources before servicing ATS unit.
• Never attempt to install electrical equipment during a thunderstorm.
• Individual equipment connected to the ATS should not draw more current than the individual
outlet's rating.
• The total load connected to the ATS must not exceed the maximum load rating for the ATS.
• Do not attempt to modify the ATS, input plugs or power cables.
• Do not drill into or attempt to open any part of the ATS housing. There are no user-serviceable
parts inside.
• Do not attempt to use the ATS if any part of it becomes damaged.
• Use of this equipment in life support applications where failure of this equipment can reasonably
be expected to cause the failure of the life support equipment or to significantly affect its safety
or effectiveness is not recommended. Do not use this equipment in the presence of a
flammable anesthetic mixture with air, oxygen or nitrous oxide.
15-09-215-93338F.indb 2
2
9/30/2015 4:56:23 PM