Metabo HPT C 1807DA Manual De Instrucciones Y Seguridad página 19

4. About the mode select function
Each time the mode selector switch is pushed, the
operation mode changes.
When Silent mode is selected, the Silent mode
indicator lamp lights up.
Silent mode reduces maximum motor RPM enabling
effi cient work with less noise.
If the load increases while the motor is operating in
Silent mode, it automatically changes to Power mode.
Additionally, if the load decreases again, it
automatically returns to Silent mode.
In Power mode, no change is made to Silent mode
even when the load decreases.
Mode
Power
Silent
NOTE
● The mode will only change after a battery is installed
and the switch is pulled once.
● The current mode will be maintained even if the switch
is on/off , or the battery is removed/reinserted.
5. About Remaining Battery Indicator
Remaining battery power can be verifi ed by pulling
on the switch to make the remaining battery indicator
lamp light up red. (Fig. 22)
The indicator lamp will change to the lighting mode
indicator lamp (green) 10 seconds after the switch is
released. The Table 5 shows the state of remaining
battery indicator lamp and the battery remaining
power.
State of lamp
As the remaining battery indicator shows somewhat
diff erently depending on ambient temperature and
battery characteristics, read it as a reference.
No-load speed
3,800 /min
2,000 /min
Table 5
Battery Remaining Power
The battery remaining power
is enough.
The battery remaining power
is a half.
The battery remaining power
is nearly empty.
Re-charge the battery
soonest possible.
6. How to use the LED light
By pressing the light selector switch on the switch
panel, the LED light mode changes as Table 6. It is
indicated by green lamp. (Fig. 23)
To prevent the battery power consumption, turn off the
LED light frequently.
Lighting mode indicator lamp
Switch panel
LED Light
Always-ON
mode
Panel
display
Always ON
(turn off after
2 minutes)
State
CAUTION
Wipe off any dirt or grime attached to the lens of
the LED light with a soft cloth, being careful not
to scratch the lens.
Scratches on the lens of the LED light can result
in decreased brightness.
NOTE
To prevent the battery power consumption caused by
forgetting to turn off the LED light, the light goes off
automatically in about 2 minutes.
English
Light section
switch
Fig. 23
Table 6
SW Always-OFF
interlocked mode
mode
Light only Always OFF
SW-ON
(Automatically
goes out
approximately
10 seconds
after the
switch is
released)
19