Metabo HPT C 1807DA Manual De Instrucciones Y Seguridad página 20

English
7. LED light warning signals (Fig. 24)
This product features functions that are designed
to protect the tool itself as well as the battery. While
the switch is pulled, if any of the safeguard functions
are triggered during operation, the LED light will blink
as described in Table 7. When any of the safeguard
functions are triggered, immediately remove your
fi nger from the switch and follow the instructions
described under corrective action.
Safeguard Function
Overload protection
Overheat protection
8. Attaching the guide (sold separately)
Install the wing bolt (B) and lock spring on the base.
Insert the guide into the base, move it left and right
and adjust the cutting position. Tighten the wing bolt
(B) and fi x the guide. The guide can be installed either
from the left or the right side of the main body.
Wing Bolt (B)
Lock Spring
Base
Wing Bolt (B), Lock Spring
Fig. 26
20
LED Light Display
On 0.1 second/off 0.1 second
On 0.5 second/off 0.5 second
Fig. 25
Base
Guide
(Rip Fence)
Table 7
Remove the cause of the overburdening.
Allow the tool and battery to thoroughly cool.
WARNING
When using the guide, avoid inclined cutting that
will allow the cut material to be caught between
the saw blade and the guide. Doing so may result
in injury.
Saw blade
9. Cutting procedures
CAUTION
● Recheck that the saw blade is securely clamped.
● Confi rm that the lever for adjusting the angle of
inclination and the lever for adjusting the slot
depth are adjusted correctly.
(1) Place the base on the material, then align the
premarked line and the saw blade with the notch at
the front of the base (Fig. 28).
Fig. 24
Corrective Action
Lumber
Guide
Fig. 27