Installing The Lid Handle; Securing The Front Shelf Brackets; Installing The Front Shelf; Mounting The Front Shelf - Pit Boss PRO Serie Montaje Y Operación

5. INSTALLING THE LID HANDLE

Parts Required:
2 x Lid Handle Bezel (#8)
1 x Lid Handle (#9)
Installation:
• Remove the pre-installed screws from the Lid Handle. From inside the
barrel lid, insert one screw to protrude to the outside. Add a Lid Handle
Bezel on the screw, then hand-tighten the screw (from the inside) into the
Lid Handle. Repeat the same installation for the other end of Lid Handle.
6. INSTALLING THE FRONT SHELF BRACKETS
Parts Required:
1 x Front Shelf Bracket / Left (#17)
1 x Front Shelf Bracket / Right (#18)
6 x Screw (#A)
Installation:
• Attach one front shelf bracket to the front of the grill barrel by using
three screws. Install each screw halfway, then tighten completely
when all three screws are mounted and aligned properly.
• Repeat the same installation for the other front shelf bracket.

7. MOUNTING THE FRONT SHELF

Parts Required:
1 x Front Shelf (#19)
2 x Washer (#B)
2 x Screw (#H)
2 x Nut (#I)
2 x Bushing (#D)
Installation:
• From underneath, insert the screw (from the outside) into the front
shelf bracket and the front shelf, then add the bushing onto the screw,
the washer, then the nut. Repeat installation for the other side of the
front shelf.
NOTE: When installed correctly, the front shelf can be raised (for use)
and lowered (for storage) with ease.
IMPORTANT: Avoid using the shelves to move or lift the grill. The
weight of the unit will cause the shelves to break, which is not
covered by warranty.
5
8
8
9
6
17
A
7
H
D
B I
19
18
9