Installing The Bottom Shelf; Mounting The Back Legs To The Main Barrel; Mounting Wheels To The Cart; Installing The Lid Handle - Pit Boss PLATINUM LAREDO 1000 PB1000PL Instrucciones Y Recetas

4. INSTALLING THE BOTTOM SHELF

Parts Required:
1 x Bottom Shelf (#19)
2 x Screw (#A)
Installation:
• Mount the Bottom Shelf to the two Front Support Legs using one screw
into each Support Leg. Ensure the flat surface of the shelf is facing up
towards the Main Barrel.

5. MOUNTING THE BACK LEGS TO THE MAIN BARREL

Parts Required:
1 x Left Support Leg / Back (#21)
1 x Right Support Leg / Back (#23)
8 x Screw (#A)
Installation:
• Mount the Back-Right Support Leg to the floor end of the Main Barrel
using three screws through the three pre-drilled holes. Install screws
from the inside of the Main Barrel. Next, mount the Back-Left Support
Leg to the hopper end of the Main Barrel using three screws through the
three pre-drilled holes. Install screws from the inside of the Main Barrel.
• Mount the Bottom Shelf to the two Back Support Legs using one screw
into each Support Leg. Tighten up all screws on Support Legs and Bottom
Shelf completely.

6. MOUNTING WHEELS TO THE CART

Parts Required:
2 x Caster Wheels (#24)
2 x Locking Caster Wheels (#25)
16 x Screw (#A)
Installation:
• Mount each Locking Caster Wheel into the bottom of each Support Leg
on the floor end of the Main Barrel using four screws in each. Mount
each Caster Wheel into each Support Leg on the hopper end of the Main
Barrel using four screws in each. Note illustration for placement guide.

7. INSTALLING THE LID HANDLE

Parts Required:
2 x Mica Sheet (#8)
2 x Lid Handle Bezel (#9)
1 x Lid Handle (#10)
Installation:
• Remove the pre-installed screws from the Lid Handle. From inside the
barrel lid, insert one screw to protrude to the outside. Add a Mica Sheet
and a Lid Handle Bezel on the screw, then hand-tighten the screw (from
the inside) into the Lid Handle. Repeat for the other end of Lid Handle.
4
5
6
24
25
7
8
8
19
21
23
24
25
9
10
9
9