Installing The Lid Handle; Securing The Cart Bar; Attaching Cylinder Wire Retainer; Securing Cylinder Support Bracket - Pit Boss PRO Serie Montaje Y Operación

• Next, twist the chimney cap onto the top of the chimney stack.
NOTE: Adjust the chimney cap to affect the airflow inside the main
grill. If cooking at low temperature, keep the cap more open. Ensure the
chimney cap allows for air to escape.

10. INSTALLING THE LID HANDLE

Parts Required:
2 x Lid Handle (#26)
Lid Handle Bezel (#20)
4 x
Installation:
• Remove the pre-installed screws from the lid handle. From inside the barrel
lid, insert one screw to protrude to the outside. Add a bezel on the screw,
then hand-tighten the screw (from the inside) into the lid handle. Repeat
same installation for other end of lid handle.

11. SECURING THE CART BAR

Parts Required:
2 x Cart Bar A (#34)
2 x Cart Bar B (#35)
4 x Screw (#J)
4 x Locking Washer (#C)
Washer (#B)
4 x
Installation:
• Secure the cart bar A and cart bar B to each support leg using a screw,
locking washer, and washer.

12. ATTACHING CYLINDER WIRE RETAINER

Parts Required:
LP Gas Cylinder Wire Retainer (#24)
1 x
Installation:
• Remove the R-clip from LP gas cylinder wire retainer.
• Attach the LP gas cylinder wire retainer to the right legs.
• Use R-clip to secure wire retainer in place.

13. SECURING CYLINDER SUPPORT BRACKET

Parts Required:
LP Gas Cylinder Support Bracket (#36)
1 x
Screw (#A)
4 x
4 x Locking Washer (#C)
4 x Washer (#B)
Installation:
• Secure the LP gas cylinder support bracket to the cart bottom shelf using
four screws, locking washers, and washers.
10
20
26
11
34
J C B
35
12
24
13
36
B
C
A
11