How To Install Your Canopy Housing; How To Assemble Your Ceiling Fan Blades - Fanimation SPITFIRE MA6721-220 Serie Manual Del Usuario

NOTE: This step is applicable after the neccessary wiring
is completed.
1. Remove one of the two shoulder screws in the
hanger bracket. Loosen the second shoulder screw
without fully removing it. Assemble canopy by
rotating key slot in canopy over shoulder screw in
hanger bracket. Tighten shoulder screw. Fully
assemble and tighten second shoulder screw that
was previously removed. (Figure 1)
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy
housing and not pinched between the housing and the
ceiling.
2. Securely attach and tighten the canopy screw cover
over the shoulder screws in the hanger bracket utilizing
the keyslot twist-lock feature. (Figure 2)
How to Assemble the Ceiling Fan Blades
1. Secure the three blades using the 1/4˝-20 screws
with flat washers and blade plate assembly through
the holes located on the bottom of the motor assembly.
(Figure 1)
NOTE: You will find the fan blade set packed in its own
carton and hardware bag in the fan box.
CAUTION
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
2. Position the trim cover onto the blade plate assembly
bottom. (Figure 2)
NOTE: Trim cover is not included with fan.
Installing the Canopy Housing
WARNING
Motor Assembly
Blade Plate Assembly
HARDWARE USED:
1/4˝-20
SCREWS
FLAT WASHER
7
Ceiling Canopy
Figure 1
Canopy Screw
Cover
Figure 2
Blade
(not included)
1/4˝-20
Screw and
Flat Washer
Figure 1
(2 each per blade)
x 6
Blade Plate Assembly
Trim Cover
(not included)
Figure 2
x 6