Tools And Materials; Before You Begin - Kohler Vanity K-2435 Manual De Instrucciones

Tools and Materials

Pencil Tape Measure
Safety Glasses
Drill

Before You Begin

NOTICE: Risk of product damage. Siliconized acrylic caulk must be
used to secure the lavatory to the vanity. Do not use 100% silicone
sealant, which will damage the finish of the vanity.
The qualified service representative will need assistance
assembling and moving the product during the installation
process. The product is heavy.
Make sure the finished wall is straight and plumb, and the floor
is flat and perpendicular to the finished wall.
Remove the drawers from the vanity before beginning this
installation. Doing so will ease the installation process. Refer to
your model's "Drawer" section contained in this guide for proper
removal.
Install the electrical supplies before installing the vanity. Refer to
the vanity roughing-in information for proper locations.
If a vessel lavatory will be installed, install the water supply and
drain lines according to the roughing-in information. The water
supply nipples must extend 3" (7.6 cm) beyond the finished wall
material.
Select the type of fastener based on the wall material. A minimum
of 50 lbs (22.68 kg) load bearing fastener is recommended.
For model K-2435: To allow the drawers to fully extend, a
minimum of 8-1/8" (20.6 cm) of clearance is required on each side
of the vanity.
For models K-2436 and K-2437: To allow the user to access the
touch switch to activate the lighting, a minimum of 2" (5.1 cm) of
clearance is required on the far left side.
1059700-2-B
Assorted Siliconized
Screwdrivers Acrylic Caulk
Plus:
• Fasteners [Min 50 lb
(22.68 kg) Load Bearing]
Level • Framing Nails
• 2x6 Lumber
4 Kohler Co.