Kohler Vanity K-2435 Manual De Instrucciones página 16

1
2
3
Drawer – K-2436, K-2437
Remove
Unplug the electrical cord from the electrical outlet, if applicable.
Slide the drawer out on the rails until fully extended. (1)
Release the electrical cord from any accessible cable clips behind
the drawer. Pull the plug up through the access hole in the
bottom of the vanity.
Pull the release latches toward you while pulling the drawer out
just enough to disengage the slides and access the end of the
electrical track. DO NOT fully remove the drawer. (2)
Gently pull the tab on top of the track clip toward you, then
disconnect the electrical track behind the drawer. (3)
Release the electrical cord from the remaining cord clips, if
applicable. (4)
Lift the drawer off the rails to fully remove the drawer. (5)
Reinstall
Slide the rails of the vanity out until fully extended.
1059700-2-B
Drawer Height
Adjustment Wheel
Rail
4 5
Track Clip
Tab
Disconnect track.
16
Release
Latch
Underside View
Tab
Kohler Co.