SKF MI-245985 Instrucciones De Montage página 3

GB, IRL, US, AUS, NZ
Mounting instructions for hub bearing
replacement in passenger cars
When mounting or adjusting hub bearings it is
extremely important for the safety of the vehicle
as well as for the operation of the bearings that
the shop manual for the vehicle concerned is fol-
lowed in detail.
Due to differences in car construction the fol-
lowing instructions are only of general bearing
technical nature and must be considered by the
mechanic from case to case to ascertain that the
bearings are mounted correctly. Otherwise the
product warranty is not valid.
In order to let a bearing operate well it is essen-
tial when mounting that the correct method is
used, that the proper tools are used and that
cleanliness is observed. The mounting should
preferably be performed in a clean room. Do not
open the bearing package until the bearing shall
be used and let the rust preventive compound
remain in the bearing during mounting.
Replacement of single row deep groove
ball bearings mounted in rigid rear axles
Dismounting:
Wheel and brake components are dismounted.
Follow the shop manual! Undo the screws for the
rear axles shield. These screws are reached
through holes in the drive shaft
Pull out the drive shaft with an appropriate
withdrawal tool.
The bearing and the locking ring are dis-
mounted with an appropriate tool. Follow the shop
manual! In some cases the bearing may be locked
to the shaft by a nut. Usually it is not necessary to
exchange the nut.
Remove the old seal.
Mounting:
1 The new bearing (1) shall be driven up on the
2 Always mount a new locking ring (2).
3 Lubricate the bearing with a proper wheel
4
Limitation of liability
The wheel bearing is a safety detail and the rec-
ommendations of the car manufacturer must
therefore be carefully followed. Incorrect mount-
ing or adjustment can cause serious bodily
injuries.
tions and safety instructions given above are
based on the experience and judgement of the
wheel bearing manufacturing companies. This is
an information which does not include or cover all
circumstances. Complete mounting instructions
can be found in the original version of the car
manufacturer's shop manual, which shall be read
and understood.
flange.
shaft against the shoulder, usually by means of
a hydraulic press. Follow the car's shop manual!
bearing grease if it is not sealed. Mount a new
seal (3) in the rear axle tube.
Mount the drive shaft in the rear axle housing in
reverse order as compared to dismounting.
The information, recommendations, specifica-
3