CAUTIONS
• Provide an individual power circuit specifically for the air condi-
tioner. As for the method of wiring, refer to the circuit diagram
posted on the inside of the access door.
• Confirm that the cable thickness is as specified in the power source
specification.
• Check the wires and make sure that they are all tightly fastened
after cable connection.
• Be sure to install a ground leakage circuit breaker in wet or moist
areas.
cable specifications
Power cord
Capacity
Normal
(BTU/h)
cross-section
Type
area
5 000 ~ 13 000
H05VV-F
0,75~1,5 mm² X3
14 000 ~ 24 000
H05VV-F
1,5~2,5 mm² X3
18 000 ~ 30 000
H05VV-F
1,5~2,5 mm² X3
18 000 ~ 30 000
H07RN-F
2,5 mm² X3
24 000 ~ 36 000
H07RN-F
2,5~4,0 mm² X3
24 000 ~ 36 000
H07RN-F
1,5 mm² X5
The cord may be different from the list above. It may be used
as the next list. And it can be larger.
0-6A, use 0,75 mm² or 18 AWG. 0-10A, use 1 mm² or 16 AWG.
0-16A, use 1,5 mm² or 14 AWG.
0-20A, use 2,5mm² or 14 AWG. 0-25A, use 2,5 mm² or 12 AWG.
0-32A, use 4 mm²
Power connecting cord
Power connecting cord 1
Normal
cross-section
Type
area
Type
H07RN-F
1,5 mm² X3
H05RN-F
H05RN-F
0,75~1,0 mm²X3
H07RN-F
1,5~2,5 mm²X3
H05RN-F
H07RN-F
1,5~2,5 mm²X4
H05RN-F
1,0 mm² X3
H05RN-F
1,00 mm² X4
H05RN-F
H07RN-F
Cooling Only
H05RN-F
0,75 mm²X4
H05RN-F
H07RN-F
1,0 mm²X4
H05RN-F
0,75 mm²X4
H05RN-F
Main
Power
Normal
Supply
cross-section
area
0,75 mm² X2
To indoor
(heat pump)
0,75 mm² X2
To indoor
(heat pump)
0,75 mm² X2
(heat pump
To indoor
& optional)
0,75 mm² X3
To outdoor
(heat pump)
0,75 mm² X2
(heat pump
To outdoor
& optional)
0,75 mm² X2
To outdoor
(heat pump)
87