Installing The Seat In The Car - JANE KOOS Insrucciones

3. Installing the seat in the car

The KOOS safety seat must be installed FACING THE OPPOSITE DIREC-
TION IN WHICH THE CAR IS TRAVELLING. Decide on the seat after rea-
ding the "Choosing where to install the safety seat" section.
To install the seat carefully follow the steps below:
3a -
Position the safety seat on the vehicle seat.
3b -
Pass the seat belt buckle over the baby's feet and fasten it.
3c -
Insert the abdominal part of the seat belt through the slots (1) on
the sides of the frame.
3d - The shoulder part of the vehicle seat belt should be passed behind
the safety seat.
3e -
Turn the handle (6) to the AUTO position, the furthest forward.
The full car symbol should be displayed on the sides of the han-
dle.
3f -
Tighten the car seat belt and fasten the locking clip (2). Make sure
that the safety seat is securely anchored by pulling it.
WARNING: For installing rear facing safety seats, the correct guides for
fitting the seat belt are marked on the chassis in blue. DO NOT use any
guide that is not described in these instructions or any on the baby
carrier that are not coloured blue.
If the safety seat is installed with the ISOfix base (optional), follow the
instructions on the base.
28
4. Putting the baby into the safety seat
4a -
Loosen the harness by puling on the shoulder straps while pressing
the tightener button (8).
4b -
Undo the clasp.
4c -
Put the baby in the safety seat, making sure that they are sitting
back in it and that their back is straight. Join the top ends of the
clasps.
4d -
Insert them in the fastener and press until you hear a click.
4e -
Tighten the shoulder straps and pull the tightener strap (7).