General Information; Delivery; Installation By Third Parties; Annual Inspection By Qualified Person (Uvv) - Bosch VLE 2130 Funcionamiento Inicial

en 16 | VLE 2130 / 2130 F | Symbols used
1.2

On the product

!
Observe all warning notices on products and ensure
they remain legible.
DANGER – Exposure of live parts on ope-
ning the VLE 2130 / 2130 F!
Risk of (fatal) injury or heart failure from elec-
tric shocks on contact with live components
(e.g. master switch, printed circuit boards).
¶
Work on electrical installations or equip-
ment is only to be performed by qualified
electricians or trained personnel under the
guidance and supervision of an electrician.
¶
Disconnect the VLE 2130 / 2130 F from
the mains before opening.
Disposal
Dispose of used electrical and electronic
devices, including cables, accessories and bat-
teries, separately from household waste.
The carrying of persons on the support arms
or in the vehicle is prohibited.
Notes on load distribution
If the gross weight of a vehicle corresponds to the ma-
ximum loadbearing capacity, the load distribution ratio
between the long and short support arms must not
exceed 3 : 2, i.e. one pair of support arms is not to be
loaded with more than 60 % of the maximum loadbea-
ring capacity (for VLE 2130 / 2130 F 1800 kg).
Maintenance schedule
Refer to "Original instructions" Section 8 for component
maintenance and intervals.
|
1 689 978 550 2017-07-14
2.

General information

2.1

Delivery

A fork lift truck must be available.
Weight of lifting platforms: approx. 600 kg.
2.2

Installation by third parties

These installation instructions and the information
given in the original operating instructions provided
must always be heeded. If the lifting platform is not
erected by Bosch customer service or a service
agent authorized by Bosch, the lifting platform
must subsequently be subjected to safety acceptance
by Bosch customer service or a service agent au-
thorized by Bosch.
Safety acceptance involves the following:
R
Electrical functional test and trial run as per
BGG 945.
R
Examination of the individual assemblies and compo-
nents.
R
Test log book entry as per BGG 945-1.
R
Personnel instruction (safety and operation).
i
Failure to conduct such safety acceptance will ren-
der all warranty claims and liability invalid.
2.3 Annual inspection by qualified person
(UVV)
In addition to checking by our customer service prior
to initial commissioning of the lifting platform, official
regulations demand safety acceptance by a qualified
person at least once per year. Bosch customer
service or a service agent authorized by Bosch will
be pleased to submit a quotation for a maintenance
agreement.
2.4

Warranty

As lifting platforms have to satisfy exacting safety requi-
rements to protect the personnel working with them, it
should be noted that the acknowledgement of warranty
claims is subject to the performance of proper safety
acceptance, maintenance work and recording in the
test log book. Exclusive use is to be made of genuine
Bosch replacement parts, as the fitting of parts
from other manufacturers invalidates the type approval
and any warranty claims.
Robert Bosch GmbH