Installing Your Appliance; Environmental Protection - Brandt AD1578X Manual De Utilización

2 / INSTALLING YOUR APPLIANCE

• ENVIRONMENTAL PROTECTION

— The cooker hood should be placed at a
distance of 65-75cm (26-30inch) from the
cooking surface for the best effect. See Pic 1.
— Install the hook on a suitable place once
the installation height is fi xed, and keep it in
line. The fi xed position of the inside chimney
bracket is the place of chimney. See Pic 2.
— Install the glass,and the extension tube.
Then fi x the outside chimney bracket on the
outside chimney,and be sure that the the
height of inside chimney can be adjusted in
it freely as well as fi xing the extension tube.
See Pic 3.
— Put the cooker hood on the hook. See
Pic 4.
— Install the chimney,and adjust the height
of the inside chimney to the positionof the
inside chimney bracket ,then fi x on it by
screw. See Pic 5.
Note
—
Any installation work must be ca-
rried out by a registered electrician or com-
petent person.
—
Do not connect the ducting system of
the hood to any existing ventilation system
which is being used for any other applian-
ce, such as warmer tube, gas tube, hot
wind tube.
—
The angle of the bend of the ventilation
pipe should not be less than 120º; you must
direct the pipe horizontally, or, alternatively,
the pipe should go up from the initial point
and should be led to an outer wall.
—
After the installation, make sure that the
cooker hood is level to avoid grease collec-
tion at on end. See Pic. 6.
Inside chimney
bracket
Inside chimney
Extension tube
Outside chimney
Right
27
EN
Pic 1
Hook
Pic 2
Outside
chimney bracket
Pic 3
Pic 4
Pic 5
Wrong
Pic 6