Balluff BTL6-A/E500/B50 M E2/E28-KA LA ZA0N Serie Instrucciones Breves página 6

BTL6-A/E500/B50 _ -M _ _ _ _ -E2/E28-KA _ _ /LA _ _ -ZA _ _
Magnetostrictive Linear Position Sensor – Rod Style
Installation
NOTICE!
Interference in function
Improper installation can compromise the function of the
BTL and result in increased wear.
► The mounting surface of the BTL must make full
contact with the supporting surface.
► The bore must be perfectly sealed (O-ring/flat seal).
The BTL can be fastened in a fitting bore (Ø 48 H8), but
must be sealed with the provided O-ring and support ring.
The body of the BTL is fastened using 3 M5 threaded pins
at a 120° angle.
For horizontal assembly with nominal lengths > 500 mm,
support the rod and tighten it at the end if necessary (only
possible with a diameter of 10.2 mm).
If installed in a hydraulic cylinder, the magnet should not
make contact with the rod. Minimum bore diameter in the
support piston:
Rod diameter
10.2 mm
8 mm
Square flange
M12x1
The square flange is included in the scope of
delivery.
2 english
Bore diameter
At least 13 mm
At least 11 mm
Mounting hole
Hydraulic cylinder
Installation in hydraulic cylinders
1. Lead the M12 contact insert through the mounting hole
and out of the cylinder.
2. Support the contact insert on the 8-mm open-end
wrench. Attach the square flange onto the M12 contact
insert and press it with force until the insert audibly
engages.
Square flange
M12 contact insert
When mounted, the contact insert protrudes from the
bottom of the square flange by approx. 2 mm.
2
3. Fasten the square flange to the hydraulic cylinder using
4 screws. When installed, the connector complies with
protection category IP67.
8-mm open-end wrench
Top view