Minimum System Requirements - Siemens SIMATIC ET 200SP Manual Del Usuario

Minimum system requirements

Ready4Linux means that the ET 200SP Open Controller CPU 1515SP PC2 (F) is supplied with a pre-installed Software
Controller CPU 1505SP (F) and a free partition for the manual installation of the Linux operating system.
Linux Debian 9 has been tested and released for use with version 20.8 of the software controller. The ET 200SP Open
Controller CPU 1515SP PC2 (F) currently only supports kernel versions from ≥4.9 to <5.x.
You also have the option of installing a different preferred Linux distribution.
In case of technical difficulties, adjust your constellation with the Linux distribution given below.
For operation you require:
Operating system:
• Linux Debian 9 on a bootable medium:
Supported kernel versions: from ≥4.9 to <5.x,
–
To enable the system to work, load a Linux image from the Debian website (https://www.debian.org/index.en.html)
ET 200SP Open Controller:
• CPU 1515SP PC2 Ready4Linux V20.8 or higher
or
• CPU 1515SP PC2 (F) Ready4Linux V20.8 or higher
Installation
Installation requirements
Please note the following requirements:
• The ET 200SP Open Controller CPU 1515SP PC2 (F) Ready4Linux must be installed.
• The CFast card must be inserted in the ET 200SP Open Controller (CPU 1515SP PC2 (F) Ready4Linux).
• The bootable medium with the Linux operating system is connected to a USB port of the
ET 200SP Open Controller (CPU 1515SP PC2 (F) Ready4Linux).
Installation
You can find the complete installation description in the CPU 1505SP (F) Ready4Linux, Version 2.7 operating instructions,
Edition 03/2019, Chapter 4: Installation
Follow the individual installation steps with the help of the operating instructions for the software controller:
• If necessary: Restore basic image (see Chapter 4.3 in the operating instructions named above)
• Install Debian Linux (see Chapter 4.4 in the operating instructions named above)
• Configure the Linux operating system (see Chapter 4.5 in the operating instructions named above)
• Install Linux components (see Chapter 4.6 in the operating instructions named above)
Install the Linux components via a package structure which is provided with the basic image.
The packages are located on the third partition of the "/dev/sda3/SWCPU/packages/debian" directory.
The packages are available in the following formats:
*.deb (Debian compatible)
–
*.rpm (Fedora compatible)
–
Commissioning in STEP 7
To enable full functionality of the CPUs with the Linux operating system, further configurations/installations are required:
• Configuring web server for use under Linux
• Establish remote access via Linux network interface
• Install driver for virtual Ethernet interface
You can find the complete description for commissioning in Step 7 in the CPU 1505SP (F) Ready4Linux, Version 2.7 operating
instructions, Edition 03/2019, Chapter 5: Commissioning in STEP 7
Product information on CPU1515SP PC2 (F/T/TF) and CPU1515SP PC2 (F) Ready4Linux
A5E44910079-AD, 08/2020
17