Pioneer AVIC-X1BT Manual Del Usuario página 13

Display unit
Power cord
Violet/white (REVERSEGEAR SIGNAL INPUT)
This is connected so that the navigation system can
detect whether the vehicle is moving forwards or
backwards. Connect the violet/white lead to the
lead whose voltage changes when the reverse gear
is engaged. Unless connected, the sensor may not
detect your vehicle travelling forward/backward
properly, and thus the position of your vehicle
detected by the sensor may be misaligned from the
actual position.
Note:
When you use the ND-PG1 speed pulse generator
(sold separately), please make sure to connect it.
When you use a rear view camera, please make
sure to connect it. Otherwise you cannot switch to
rear view camera picture.
See Page 15.
Be sure to use only the supplied extension lead. Use of another lead could
cause fire, smoke and/or damage this product.
Black, Orange/white, Red, Yellow
Extension lead
(for reverse signal)
Check the position of your vehi-
cle's reversing lamp (the one that
lights up when the gearstick is in
reverse [R]) and find the reversing
lamp lead in the boot.
Note:
Cords for this product and those for other products may
be different colours even if they have the same func-
tion. When connecting this product to another product,
refer to the supplied Installation manuals of both prod-
ucts and connect cords that have the same function.
Yellow/black (GUIDE ON)
When combining this navigation system with the
other Pioneer audio unit for the vehicle, if the vehicle
stereo has yellow/black leads, connect them to those
leads. In this way, the vehicle stereo is automatically
muted to reduce the vehicle stereo volume when;
• the guidance audio is output.
• the cellular phone is used via Bluetooth adapter.
• you operate the system by voice.
See Page 9.
Connection method
Fuse resistor
5 m
Clamp the reversing lamp
lead.
Clamp firmly with
needle-nosed pliers.
Reversing lamp lead
12