Pioneer AVIC-X1BT Manual Del Usuario página 21

• If installation angle exceeds 30º from horizontal, the display unit might not give its opti-
mum performance.
• The cords must not cover up the area shown in the figure below. This is necessary to
allow the amplifiers and navigation mechanism to heat dissipate freely.
Display unit
Do not cover these areas.
• The semiconductor laser will be damaged if it overheats, so don't install the product
anywhere hot — for instance, near a heater outlet.
• When installing the Hide-away unit in the boot, use the extension cable (e.g. CD-
SC300E) (sold separately).
• Do not install the display unit in a position where the opening of the LCD panel is
obstructed by any obstacles, such as the gearstick. This may cause interference with the
gearstick, or a malfunction of the mechanism of the display unit.
• Install the microphone in a position and orientation that will enable it to pick up well the
voice of the person operating the system by voice.
30°
Hide-away unit
Do not cover this area.
20