Grounding Instructions - Slime 40029 Instrucciones

TROUBLESHOOTING
Inflator does not turn on:
1. Make sure plug is fully inserted into the inflator and wall outlet.
2. Make sure the outlet is live by using a known functional electronic device.
3. Check the extension cord for damaged prongs, frays or breaks.
Inflator runs but does not inflate:
1. Be sure the air hose connector is tightly screwed onto the valve stem.
2. Check tire for leaks.
3. Check air hose for breaks and leaks at fittings.
4. Check tire valve for leaks.
5. Check valve core for damage.
Inflator runs slowly:
1. The inflator may have overheated from excessive use. Shut it off and allow it to cool for
25 minutes.
NOTE: If tire is totally deflated, it is possible that the tire could separate from the rim
allowing air to leak out when trying to inflate. In the event this occurs, it may be necessary
to jack up the tire prior to inflation.
GROUNDING INSTRUCTIONS: Use only a 3-wire extension cord that has a 3-blade grounding
plug, and a 3-slot receptacle that accepts the plug on the product. Make sure your extension
cord is not damaged. When using an extension cord, be sure to use one heavy enough to
carry the current your product draws. For lengths less than 100 ft, 18 AWG extension cords
shall be used. An undersized cord results in a drop in line voltage and loss of power and
overheating.
Limited Warranty: Manufacturer's liability is limited to product replacement or cash refund with proof of purchase.
QUESTIONS OR COMMENTS: Call 888-45-SLIME or visit www.slime.com
Accessories Marketing, Inc, a division of Illinois Tool Works, Inc. 125 Venture Drive, Suite 210, San Luis Obispo, CA 93401 USA
Slime® is a trademark of Illinois Tool Works, Inc., registered in the U.S. and other countries.