Connecting The Power Cord (1) - Pioneer AVIC-8DVD Manual De Instalación

Connecting the System

Connecting the power cord (1)

Speed detection circuit lead
Vehicle injection computer
Note: The position of the speed detection circuit
depends on the vehicle model. For details,
consult the relevant documents from Pioneer.
When making connections for a model not listed
in those documents or for which connection to
the speed detection circuit is too difficult,
connect the separately sold ND-PG1 speed pulse
generator to the pink lead.
Note: The position of the parking brake switch
depends on the vehicle model. For details,
consult the vehicle owner's manual or dealer.
Connection method
7
Connector
Clamp the parking brake
switch power supply side
lead.
Clamp firmly with
needle-nosed pliers.
Connection method
Pink (CAR SPEED SIGNALINPUT)
The mobile navigation system is connected here to detect
the distance the vehicle travels. Always connect the
vehicle'sspeed detection circuit or the ND-PG1 speed
pulse generator, sold separately. Failure to make this
connection will increase errors in the location display.
Lightgreen
Used to detect the ON/OFF status of the parking brake.
This lead must be connected to the power supply side of
the parking brake swich. If this connection is made
incorrectly or omitted, certain functions of your
navigation system will be unusable.
Power supply side
Ground side
Pass the extension cord
and the lead for the
speed detection circuit
through this hole.
Clamp firmly with
needle-nosed pliers.
Close the cover.
Parking brake switch