Boiling Water; Keeping Water Warm - Beem Basic Selection MD-357B Manual De Instrucciones

EN
Use
NOTICE
• Only use the device if the lid has been closed correctly and the kettle is placed on the
base station correctly!
• Do not operate the device without water.
If water needs to be added, switch off the device, pull the mains plug out of the socket
and allow the device to cool down for a few minutes.

Boiling Water

1. Pour water into the kettle (8) (see the "Pouring In Water" chapter) and place it on the base
station (5). The display (7) lights up and shows the current water temperature (15).
2. Press the button | (17).
process. In addition, the temperature prevailing in the kettle is shown on the display.
3. As soon as the water has boiled (100°C), you will hear 3 beeps and
on the display. The device switches off.

Keeping Water Warm

1. Pour water into the kettle (8) (see the "Pouring In Water" chapter) and place it on the base
station (5). The display (7) lights up and shows the current water temperature (15).
The display switches off after approx. 3 seconds if no button is pressed.
2. Press the PROG button (18) and use the buttons + (16) and – (19) to set the desired
water temperature at which the water should be kept warm.
– The device switches on automatically after 3 seconds.
– As soon as the water has boiled, you will hear 3 beeps and
display.
– As soon as the temperature drops 5°C below the selected temperature, the kettle heats up
to this temperature again.
The keep-warm function switches off automatically after 120 minutes. It can be switched
off at any time using the button | (17).
The Temperature Levels
You can select temperatures of between 40 and 100°C with the kettle.
40°C
ideal for baby food, for mixing facial masks, oats/porridge
50°C ideal for milk powder
60°C
ideal for very delicate green tea
70°C
ideal for white tea
(11) lights up on the display and the device starts the heating
(13) will light up
(11) appears on the display.
(12) will light up on the
20