Hints And Tips - EAS ELECTRIC EMIH600-FX1 Manual De Instrucciones

1. Switch the power to the cooktop off.
Spillovers on the
2. Soak up the spill
touch controls
3. Wipe the touch control area with a
5. Switch the power to the cooktop

7. Hints and Tips

Problem
The induction hob
cannot be turned on.
The touch controls are
unresponsive.
The touch controls are
difficult to operate.
The glass is being
scratched.
Some pans make
crackling or clicking
noises.
The induction hob
makes a low humming
noise when used on
a high heat setting.
Fan noise coming from
the induction hob.
clean damp sponge or cloth.
4. Wipe the area completely dry
with a paper towel.
back on.
Possible causes
No power.
The controls are locked.
There may be a slight film of
water over the controls or you
may be using the tip of your
finger when touching
controls.
Rough-edged cookware.
Unsuitable, abrasive scourer or
cleaning products being used.
This may be caused by the
construction of your cookware
(layers of different
vibrating differently).
This is caused by the technology
of induction cooking.
A cooling fan built into your
induction hob has come on to
prevent the electronics
overheating. It may continue to
run even after you've turned the
induction hob off.
• The cooktop may beep and turn
itself off,
may not
liquid on them. Make sure you wipe the
touch control area dry before turning the
cooktop back on.
Make sure
connected to the power supply and
that it
Check whether there is a power
outage in your home or area. If
you've checked everything and the
problem
technician.
Unlock the
'Using your induction cooktop' for
instructions.
Make sure the touch control area is
dry and use the ball of your finger
when touching the controls.
the
Use cookware with flat and smooth
bases. See
cookware'.
See 'Care and cleaning'.
This is normal for cookware and does
not indicate a fault.
metals
This is normal, but the noise should
quieten down or disappear completely
when you decrease the heat setting.
This is normal and needs no action. Do
not switch the power to the induction
from hob off at the wall while the fan is
running.
19
and the touch
function while there
What to do
the induction hob
is switched
persists, call a qualified
controls. See section
'Choosing the
controls
is
is
on.
right
V.2