Infiniton SSDC-4630 Manual De Instrucciones página 10

3.Introduction for remote controller and light board
On / Off button: when press the button, the remote controller is cycling switched following "open → closed →
open" . When you first power up from Off → On, the working status remains on default setting (Temperature
setting 25℃, Auto mode, Auto wind speed, Auto swing, Auto throttle, No lights, No strong wind, No purification,
No sleep, No timer, No lock button). None-first time when power on from Off → On, the working state remains
the state before shutdown. after shutdown functions of lighting, purification, sleep, strong wind and timing will
be cancelled.
Mode key: when pressing mode key, the remote control cycling switches according to the "automatic
→cooling → dehumidification→ heating→ventilation → automatic".
Increase button: on dehumidification mode and auto mode, the temperature will not change when this button
is pressed. In the other mode, each press of this button will plus 1 on the set temperature, increments occur in
order of "16℃ → 17℃ → ... → 31 ℃ → 32 ℃".
Wind direction button: wind direction on the first power on is defaulted for the swing state, when press this
button, the unit is cycling switched following "swing → stop → swing".
Wind speed button: on the first power on, wind speed is defaulted for auto wind speed, when in
dehumidification mode, wind speed is fixed at low wind, and the wind speed can not be adjusted, when press
wind speed button the remote controller does not respond. For the other modes, when you press this button, it
is cycling switched following "Auto wind → High wind → Middle wind → Low wind → Auto wind" .
Timer button: it is defaulted for no timer state, when press this button, the timer setting is performed in one
hour increments, the timer is set in order of 1H → 2H → ... → 24H → cancel → 1H ... cycle. Press the timer
button in the Off state to set On, in the power on state, press timer button to set the timer switch. When the
timer is set, every one hour minus one, and power on or shut down until the time runs out, while closing the
timer display. If the timer is set, when press the mode button, the time setting will not be canceled. If the timer is
set, pressing on another button will release the time set on the timer.
Sleep button: press sleep button, it is cycling switched following "sleep → cancel sleep → sleep", when sleep
is set, after the conversion of mode, the sleep is not canceled. When press sleep button to set sleep, wind
speed is automatically switched to low wind, but by pressing the wind speed button it is possible to adjust the
wind speed (except dehumidification mode).
Lock button: it is defaulted for no lock button status, when press this button, the remote controller is cycling
switched following "lock button → cancel Lock button →lock button" . When there is a lock button, all buttons
except the lock button of the remote controller do not work. (Note: When there is a lock button, the button on
the remote controller and the air conditioner operate plate of standby unit are automatically locked, when press
this button again, the remote controller and the airconditioner will all be automatically unlocked. in discrete
unit, only the remote controller is locked, the emergency button will not be locked, but the main plate response.
)
6